Community technical support mailing list was retired 2010 and replaced with a professional technical support team. For assistance please contact: Pre-sales Technical support via email to sales@march-hare.com.
OS: Windows 2000 Professional Network card exists. Machine is a member of NT 4.0 domain cvsroot is :ntserver:machine_name:D:\CVSROOT It seems that there is some kind of timeout after approx.. 15 minutes, but I'm still checking this theory. I get error on first try, all subsequent calls are executed correctly. > -----Original Message----- > From: Bo Berglund [mailto:Bo.Berglund at system3r.se] > Sent: Wednesday, March 13, 2002 3:35 PM > To: 'Trogrlic Zeljko'; 'CVSNT' > Subject: RE: [Cvsnt] Named pipe error > > > How did you set your cvsroot? Like so: > :ntserver:machinename:d:/cvsrepo or similar? > > I have seen this problem when I connect through a VPN to a > remote location > (not your case though). In these cases I have had to map a > drive letter to > a share on the remote server to make it work. Basically the > ntserver uses > named pipes for authentication and if there is already a > connection like > for a mapped drive then all is well. But otherwise > authenticatition must be > made using the pipe. > What kind of network protocols do you have on the "same" machine? > And which operating system? > If you use W2000 and you don't have a network cable attached > I suspect that > you will get this error if the only network protocol is > TCP/IP because it > unloads completely when the network cable is pulled out. Some > new Microsoft > idea introduced with W2000. To avoid that you must add the > Microsoft Loopback > Network adapter and bind it to TCP/IP too. THen it will > always stay loaded. > > HTH > > /Bo > > > -----Original Message----- > From: Trogrlic Zeljko [mailto:zeljko.trogrlic at siemens.hr] > Sent: den 13 mars 2002 15:01 > To: 'CVSNT' > Subject: [Cvsnt] Named pipe error > > > Hello, > > I'm using Wincvs over ntserver protocol. Server is located on the same > machine. CVSNT version is 1.11.1.3. Very often Wincvs can't > connect to cvsnt > with following error message: > > Wincvs 1.2: > cvs [update aborted]: Couldn't connect to hro0030c, named pipe error 6 > > Wincvs 1.3: > cvs [update aborted]: Couldn't connect to named pipe on > remote machine: > Error 64 > > Both programs use cvs.exe from cvsnt > > Any ideas? > _______________________________________________ > Cvsnt mailing list > Cvsnt at cvsnt.org > http://www.cvsnt.org/cgi-bin/mailman/listinfo/cvsnt https://www.march-hare.com/cvspro/en.asp#downcvs > _______________________________________________ Cvsnt mailing list Cvsnt at cvsnt.org http://www.cvsnt.org/cgi-bin/mailman/listinfo/cvsnt https://www.march-hare.com/cvspro/en.asp#downcvs